Life Fitness Bicycle Upright and Recumbent Bike User Manual

Essential & LF Sport Bikes Upright and Recumbent

Console Assembly Service Kit Replacement

Special Service Tools Required: NONE

Replacement of the Console Assembly is basically the same

for both Essential & LF Sport Bikes (Upright/Recumbent). The

only difference is that on the Upright Bike, the Console

Support Plate is welded to the Console Post, while on the

Recumbent Bike, the Accessory Tray Bracket and the Console

Plate are secured together on the Console Post by two ½”

screws. These two screws along with the Console screws (4)

must be replaced. Regardless, the Console Assembly Service

Kit includes the Console Assembly along with six new,

specially designed screws, which have little tabs on the back

of the screw head to enhance grounding capabilities. All six of

these screws will be used for the Recumbent Bike only. While

only four of these screws will be used for the Upright Bike.

Console

Asse m bly

Sc re ws(4)

1. Remove four 1” screws from the back of the Console

Assembly (Upright or Recumbent), and discard.

2. Lift the Console Assembly off just enough to disconnect

the Main Wiring Cable, and then remove the Console

Assembly. Return old Console back to Life Fitness Co.

Upright

3. In the case of the Recumbent Bike, remove

the two ½” screws securing the Accessory

Tray Bracket and Console Support Plate to

the Console Post, and discard. Then install

with the two new, ½” screws in the kit.

Acc essory Tra y

Bra c ke t Sc re ws(2)

Console

Asse mbly

Sc re ws(4)

Note: To avoid alignment problems and handling

of loose components, remove and replace one

screw at a time in the Console Support Plate.

4. Install the new Console Assembly in reverse

order using the four new, 1” screws in the kit.

Note: The new screws MUST replace the old

screws.

Re c um be nt